a
abdul_haseebb_

Abdul Haseeb

@abdul_haseebb_

Electrical Engineer 'PCB Design, Embedded Systems and MATLAB Simulink'

Pakistan
English, Urdu, Hindi
About me
Electrical engineer who designs, simulates and builds electronic systems end to end. 1- PCB design (KiCad): mixed-signal, isolated and mains-powered boards, Gerbers and BOM ready for JLCPCB 2- Embedded: ESP32, STM32 and Arduino firmware in C/C++, ADC data acquisition, Ethernet and IoT 3- Simulation: MATLAB/Simulink, power electronics (converters, rectifiers) and PI/PID control; Proteus circuits 4- Analog: op-amp and instrumentation-amp signal conditioning 5- Testing: bring-up and debugging with oscilloscope and multimeter Final-year EE student at NUST with R&D and industrial internships.... Read more

Skills

a
abdul_haseebb_
Abdul Haseeb
Offline • 
Average response time: 1 hour

See my services

Embedded Systems & IoT
I will do matlab simulink simulations for power electronics
From$15 / projectMore details

Portfolio

Work experience

National_University of Sciences and Technology (NUST)

R&D Intern

National University of Sciences and Technology (NUST) • Full-time

Aug 2026 - Sep 2026 • 1 mo

Developed, tested and field-deployed a real-time embedded telemetry system for passive underwater acoustic monitoring. • Bare-metal firmware on an STM32F7 (Nucleo-F767ZI): ADC and timer configuration for continuous acoustic sampling at 400 kSPS, with buffering and real-time packet transmission over Ethernet. • Analog front-end built around an AD8421 instrumentation amplifier for DC offset removal and noise filtering of the acoustic sensor signal. • Buck-converter power supply and an Ethernet-to-fibre media converter for the long cable run to shore, housed in sealed junction boxes. • Solved sampling-versus-transmission timing issues to stream without data loss; validated through extended bench tests, then deployed and verified on site with live spectrogram monitoring.

Artistic_Milliners

Electrical Engineering intern

Artistic Milliners • Full-time

Jul 2026 - Aug 2026 • 1 mo

Four-week industrial placement in the Electrical Department of a large denim manufacturing facility. • Inspected LT rooms, PFI panels and distribution boards across three sub-units using structured electrical safety checklists • Conducted thermographic surveys, including the solar inverter and battery room, where I identified an AC failure that had raised ambient temperature to about 70°C • Studied a SCADA-based energy monitoring system managing 22 LT panels fed by grid, solar, gas and diesel generation • Worked with single-line diagrams, Lockout/Tagout procedures and hotspot severity classification (C0–C3) • Designed a forward/reverse 3-phase motor control circuit with electrical and mechanical interlocking, as a supervised exercise