Browse categories
Explore
Fiverr Pro
English
$
USD
I will design mmwave radar pcb, rf circuit, antenna, sensor and embedded firmware
CAN Bus Firmware and ECU Systems
I’m an Embedded Systems and Automotive Electronics Engineer specializing in CAN Bus, ECU communication, automotive diagnostics, and embedded firmware
I develop and debug automotive systems using **STM...
About this Gig
HELLO BUYER!!!
WELCOME TO MY INBOX!
I can help turn your concept, schematic, or technical requirements into a professional and manufacturing-ready solution. I specialize in mmWave radar electronics, RF PCB design, antenna integration, sensor interfaces, embedded systems, and firmware development.
What I offer:
- mmWave radar PCB design
- RF circuit design and integration
- Radar sensor integration
- Component selection and placement
- Schematic capture and PCB layout
- Gerber, BOM and manufacturing files
- PCB design review and optimization
- Prototype and production support
Why choose me?
- Professional and organized PCB designs
- Focus on signal integrity and reliable hardware
- Attention to RF layout and antenna considerations
- Clean, manufacturable PCB layouts
- Clear communication throughout the project
Have a project in mind? Send me your requirements, schematic, datasheet, or block diagram before ordering. Let's discuss your project and build the right mmWave radar solution for you.
Other Electronics Engineering Services I Offer
FAQ
Can you design a complete mmWave radar system?
Yes. I can work on the mmWave radar PCB, RF circuit, antenna integration, sensor interface, power section, and embedded firmware based on your project requirements.
What information do you need to start the project?
Please provide your project requirements, block diagram, schematic, preferred radar sensor/module, datasheets, target frequency, PCB requirements, and firmware specifications if available. If you only have an idea, you can contact me first to discuss the requirements.
Can you design RF and antenna sections for mmWave applications?
Yes. I can help with RF circuit design, RF PCB layout, antenna integration, impedance-controlled routing, and related mmWave design considerations, depending on the required frequency and radar architecture.
Do you provide manufacturing-ready PCB files?
Yes. Depending on the package, I can provide Gerber files, BOM, schematic files, PCB source files, and other required manufacturing documentation.
Can you develop firmware for the radar PCB?
Yes. I can develop or integrate embedded firmware for supported microcontrollers and radar/sensor systems, including communication interfaces such as SPI, UART, I2C, USB, CAN, and other required interfaces.
