Browse categories
Explore
Fiverr Pro
English
$
USD
I will design power switching circuits for mechatronics and automation projects
Electronics Design Engineer, Sensor And Signal Conditioning Specialist
I am Adrian an Electronics Design Engineer specializing in custom sensor interfaces, analog circuits, signal conditioning, and embedded electronics. I design practical circuit solutions for sensors, A...
About this Gig
HELLO WELCOME TO MY GIG!!!
I design custom power switching circuits for mechatronics, robotics, automation and embedded systems, focusing on reliable control of motors, solenoids, actuators, LEDs, heaters, pumps and other DC loads.
Your circuit can be designed around the required voltage, current, switching method, load characteristics and controller interface, with careful consideration for component ratings, switching performance, protection and practical implementation.
Services Included:
- MOSFET and IGBT switching circuits
- High/low-side switching
- Relay and transistor driver circuits
- PWM power control
- Motor and actuator switching
- Solenoid and inductive-load drivers
- Current sensing and protection
- Flyback and transient protection
- Schematic and component selection
- BOM and PCB-ready design
I can work from your specifications, existing schematic, datasheet or project concept.
Message me before placing your order to confirm the project scope!!!.
Other Electronics Engineering Services I Offer
FAQ
Can you design MOSFET switching circuits?
Yes. I can design MOSFET-based switching stages for suitable DC loads and mechatronics applications.
Can you control motors and solenoids?
Yes. Motor, solenoid, actuator and other inductive-load switching circuits can be designed according to their electrical requirements.
Can you design high-side and low-side switching?
Yes. The appropriate topology can be selected based on the load, supply and controller requirements.
Can you include protection?
Yes. Depending on the application, protection may include flyback, transient, overcurrent and gate-protection circuitry.
Can you design the PCB?
Yes. PCB layout can be included when required and when the project scope calls for it.
Can you work from an existing circuit?
Yes. I can review an existing schematic and develop or improve the switching section based on the project requirements.
