Browse categories
Explore
Fiverr Pro
English
$
USD
I will design and simulate your pcb, patch or wire antenna with gerber files
About this Gig
Need an antenna that actually works on your board? I am an RF / electrical engineer and the developer of RF Antenna Designer, an antenna design tool with its own Method-of-Moments and full-wave FDTD solvers.
What I can design:
- Printed PCB antennas: IFA / meandered IFA for BLE, Wi-Fi, Zigbee, LoRa
- Microstrip patch antennas (probe, inset or edge feed) on FR4, Rogers and more
- Wire antennas: dipole, monopole, Yagi-Uda, helix, loop
- Antenna arrays and MIMO isolation / ECC analysis
You receive:
- Exact dimensions tuned to your frequency and board size
- S11, Smith chart, 3D radiation pattern, gain and efficiency
- Gerber and DXF files ready for fabrication (Standard and Premium)
- A clear PDF report you can share with your team
Already have a prototype? Send me your VNA measurement (.s1p) and I will retune the antenna.
Please message me before ordering with your frequency, board size and substrate, so I can confirm the best package.
Specialization:
Simulations
•
Analysis
File format:
Gerber
Software:
Other
Interface:
Wi-Fi
•
BLE
•
BT
•
LTE
•
CAT-M1
•
NB-IoT
•
Other
My Portfolio
FAQ
What information do you need to start?
Your target frequency or band, board size and antenna keep-out area, substrate (e.g. FR4 1.6 mm), feed type and connector. A board outline (DXF, Gerber or a sketch) helps a lot.
Will the antenna work in my product without changes?
Simulation gives a strong starting point, but enclosures, nearby components, batteries and cables detune antennas. I recommend measuring the prototype; I can retune the design from your VNA measurement.
Can you design the antenna to fit my existing layout?
Yes. Send me the board outline and the area reserved for the antenna, and I will design the antenna to fit that space.
Do you provide a matching network?
Yes. If the antenna needs one, I design an L-match and give you the component values in nH and pF. It is included in Premium and available as an extra for the other packages.
Which file formats will I receive?
A PDF report with dimensions and results, plus Gerber and DXF files for fabrication in Standard and Premium. Simulation source files are available as an extra.
