I will develop embedded rust firmware for stm32 and nrf52 with embassy or rtic
Embedded Firmware Engineer, STM32, ESP32, nRF52, Linux, AOSP
Level 1
Has met certain performance criteria and shows strong potential in the marketplace.
About this Gig
Want firmware that cannot crash from a buffer overflow or a data race? I write embedded Rust firmware for STM32, nRF52/nRF53 and RP2040 using Embassy, RTIC and embedded-hal. Memory safe, modern firmware with the performance of C.
What I deliver:
- New firmware in Rust: async tasks with Embassy, or real-time scheduling with RTIC
- Drivers for sensors and peripherals: SPI, I2C, UART, ADC, PWM, DMA, USB
- BLE on nRF52 with SoftDevice or Nordic's nrf-softdevice crate
- Porting existing C/C++ firmware to Rust, step by step
- Bootloaders, OTA/DFU updates and flash storage
- Low power design for battery devices
- Unit tests, hardware-in-the-loop tests and CI with probe-rs and defmt
- Code review and fixes for your existing Rust project
Every order includes idiomatic Rust, a cargo project that builds from a fresh clone, flash and debug instructions and a short architecture note.
Why me:
- Commercial embedded experience in both C and Rust
- Tested on real hardware with probe-rs before delivery
- No unsafe code unless required, and every unsafe block documented
Message me with your MCU, board and goals before ordering and I will confirm scope and timing.
My Portfolio
FAQ
Which chips do you support in Rust?
STM32 (all Cortex-M families), Nordic nRF52832, nRF52840, nRF5340, Raspberry Pi RP2040 and ESP32-C3/C6 (RISC-V). Others on request if a HAL crate exists.
Embassy or RTIC?
Embassy for async, connectivity and low-power designs. RTIC for hard real-time control loops. I will recommend one for your project.
Can you port my C firmware to Rust?
Yes. I port module by module, keeping the product working at each step, and provide a comparison of binary size and timing.
Do I get the source code?
Yes. The full cargo workspace, build config, probe-rs flashing scripts and docs. You own everything.
Do you need my hardware?
Usually not. I test on Nucleo, nRF52 DK and Pico boards. For custom boards, send the schematic. Shipping one board speeds up complex work.
Do you also design the PCB?
Yes. I can design the schematic and PCB layout for your board and deliver it with the firmware. Message me and I will quote the hardware part separately.
What do you need to start?
MCU part number or board, a description of the required behaviour, schematic or pinout, datasheets for connected parts, and any existing code.

