Browse categories
English
$
USD
Connect to your AI
I will design lora sensor node pcb esp32 stm32 lorawan iot hardware mcu interface
LoRa and LoRaWAN PCB Designer Sensor Nodes, Gateways and Industrial IoT
Hello
I design custom LoRa and LoRaWAN PCB hardware for wireless sensor nodes, environmental monitoring, gateway systems and industrial RTUs. My services cover ESP32 and STM32 integration, SX1262/SX1...
About this Gig
Hello!!
Need a custom LoRa sensor node PCB for a wireless IoT product or prototype? I design sensor-node hardware around your LoRa radio, MCU, sensors and power requirements.
What I Offer
- LoRa/LoRaWAN sensor-node PCB design
- SX1262, SX1276 or compatible radio-module integration
- ESP32, STM32 and other MCU interfaces
- Temperature, humidity, pressure and digital sensor inputs
- Analog sensor conditioning and ADC interfaces
- Battery-powered, low-power sensor electronics
- Battery charging and power management
- RF module, antenna connector and layout considerations
- UART, I2C, SPI, GPIO and debug interfaces
- 2-layer or 4-layer PCB layout
- Schematic, component selection and BOM
- ERC/DRC, footprint checks and DFM review
- Gerbers, editable source and 3D/STEP when agreed
I can work from your brief, block diagram, datasheets or schematic. Firmware, gateway/cloud setup, fabrication, certification and field testing are excluded unless agreed. Range and battery life depend on radio, antenna, environment, duty cycle and firmware.
Message me with sensors, radio/module, frequency band, power source, board size and required files to confirm scope.
FAQ
Can you design a LoRa sensor node around my selected modules?
Yes. Share the radio/MCU part numbers, sensor list, frequency band, power source, board size and required files. I will confirm the scope before ordering.
Can you integrate sensors and a LoRa radio on one PCB?
Yes. I can integrate supported digital or analog sensors, the selected radio/module, MCU interfaces, power circuitry and connectors based on your requirements.
Does this Gig include LoRaWAN firmware or a gateway?
This Gig covers PCB hardware and agreed design files. Firmware, gateway setup, cloud dashboards, fabrication and certification are excluded unless separately agreed.
