I will design your power electronics pcb board

The client will receive PCB gerber files, Bill of Materials (BOM) and a 3D model view. If required, a centroid file will be generated. For an extra charge the client can be guided to fabricate the board himself at a desired PCB manufacturer.

Any kind of electrical analysis, RF analysis, Power analysis (current, Isolation, etc.), Electrical simulation. Anything out of the electronic design scope like marketing study, product viability, product cost analysis etc.

The source file in KiCAD EDA, Prototype boards or fully functional prototype assembly if requested as an extra. The components’ price is not calculated in the extra service. Prototyping will also delay the delivery due to the extra technological steps involved.

KiCAD is used exclusively as design tool.

All boards will be designed with separation from the signal and power stage, EMI compliance and noise reduction in mind. Ground plane will be used for minimization of electrical noise and better cooling. I am experienced in power converter design and will design the converter professionally.

Yes, to a certain extend. Assistance will be provided in any doubt or problem you encountered in the manufacturing process and technical support. After all I am here to help you.

Minimal modifications or changes are included in the final cost of any orders. This should be discussed in advance, prior delivery. However this will not cover major modifications that will be a new project.

Usually complex designs contain more components and/or specific routing, which results in more technical time to complete. That’s why the delivery time increases with complex designs.

Yes, however make sure you contact me to discuss details before we start. Details such as PCB manufacturer, component sourcing, extra time for delivery, delivery address and other preferences have to be set clear.