I will configure and optimize klipper firmware for your 3d printer

Klipper errors, MCU connection failures, a printer that won't home, or a setup that never prints right? I'll configure and optimize Klipper firmware so your 3D printer runs smoothly and prints well.

WHAT I DO

Klipper install on Raspberry Pi or another host (Mainsail / Fluidd / Moonraker)

Build and flash firmware for your mainboard (BTT SKR, Octopus, Creality, Ender, CR-10 and more)

Custom printer.cfg: steppers, TMC drivers, heaters, fans, endstops

BLTouch / probe setup, bed mesh and Z-offset

Input shaper and pressure advance tuning*

Macros: START_PRINT, END_PRINT, filament change, slicer start G-code

Touchscreen/display and WiFi board setup

Troubleshooting existing Klipper errors

Marlin-to-Klipper conversion

Bed mesh needs a probe, and input shaper tuning needs an accelerometer (e.g., ADXL345). No accelerometer? I'll guide you on what to buy and how to wire it.

WHAT I NEED FROM YOU

Printer model, mainboard, host device, your current config or error log, and remote access (SSH/AnyDesk) or a willingness to follow my guided steps.

Not sure which package fits? Message me before ordering and I'll recommend the right one.