I will execute technical feasibility for your patented idea

You’ll receive a clear block diagram, a short architecture document, and a basic component selection guide with notes on power rails, interfaces and key risks.

Yes, absolutely. Many of my clients are non-technical founders. I’ll ask you simple questions about what the product should do, and I’ll translate your answers into clear technical requirements and a hardware plan.

Yes. This gig covers only architecture and feasibility, but I also offer separate gigs and custom offers for full schematic design and PCB layout in Altium or KiCad if you’d like me to continue the project.

I mainly focus on embedded systems and IoT devices using platforms like ESP32, STM32, Arduino, Raspberry Pi and custom SoCs. If your project is outside this scope, send me a message and I’ll tell you honestly if I’m the right fit.

No, this gig does not include firmware or driver coding. I will, however, choose suitable MCUs/modules (ESP32, STM32, Arduino, Raspberry Pi, etc.) and define interfaces so that firmware development is straightforward later.

Yes. In the architecture phase I can flag certification and EMI/EMC risks. After the architecture is done, I can offer separate gigs for PCB design, EMI/EMC-friendly layout and preparation for CE/FCC compliance.

For hardware I mainly use Altium Designer and KiCad, and I commonly design around ESP32, STM32, Arduino, Raspberry Pi and custom SoCs for IoT and embedded systems.

Place an order on the package that fits you best and fill in the requirements form with your idea, constraints and any existing docs. If you’re unsure which package to choose, message me first with a short summary and I’ll guide you.