Browse categories
Explore
Fiverr Pro
English
$
USD
I will develop nfc rfid hardware, rf pcb antenna tuning embedded pcb, microwave circuit
RF Microwave Hardware Engineer , PCB, Antenna And NFC RFID Design
I am Elspeth Radclif, a BSc graduate and RF & Microwave Hardware Design Engineer specializing in RF PCB design, antenna tuning, NFC/RFID hardware, microwave circuits, amplifiers, filters, and embedded...
About this Gig
Looking for an engineer to develop NFC, RFID, RF, antenna, or embedded hardware?
I can turn your idea, schematic, or existing PCB into a practical, prototype-ready hardware solution.
Services I offer:
- NFC/RFID hardware & antenna design
- RF PCB design and layout
- Antenna tuning & impedance matching
- RF front-end & microwave circuits
- RF transmission lines and matching networks
- Embedded/MCU hardware development
- PCB schematic and layout
- RF troubleshooting and optimization
- Existing PCB analysis and improvements
- Prototype-ready hardware design
What you get:
- Professional engineering design
- RF-aware PCB layout and signal integrity
- Practical component selection
- Clear communication
- Revisions and design optimization
Whether you're developing an NFC/RFID product, IoT device, RF module, embedded system, or prototype, I can help bring your hardware idea to life.
Have an existing RF or PCB problem? Send me your schematic, PCB files, datasheets, or test results and I'll help identify possible issues.
Please contact me before ordering
RF and microwave projects vary in complexity, so message me first with your requirements. I'll review the project and recommend the right package.
FAQ
Can you design a complete NFC/RFID PCB?
Yes. I can help with the schematic, RF section, antenna, matching network, PCB layout, and embedded hardware depending on your requirements.
Can you design or tune an NFC/RFID antenna?
Yes. I can work on antenna design, impedance matching, tuning, and optimization based on your target frequency and application.
Can you work with an existing PCB design?
Yes. Send your schematic, PCB files, datasheets, or test results and I can review the design and help identify possible RF or hardware issues.
Do you work with RF and microwave circuits?
Yes. I can work on RF front-end circuits, matching networks, transmission lines, filters, and other microwave/RF sections depending on the project complexity.
Can you design embedded hardware with an MCU?
Yes. I can develop MCU-based hardware and integrate sensors, communication interfaces, RF modules, and other peripherals.
Should I contact you before ordering?
Yes. RF, antenna, and microwave projects can vary significantly in complexity. Please message me first so I can understand your requirements and recommend the right package.
