Browse categories
Explore
Fiverr Pro
English
$
USD
I will design lora pcb, rf antenna, pic, mqtt and AWS iot
Embedded Systems and IoT Hardware Engineer PCB and RF Design
I’m David, an Embedded Systems & IoT Hardware Engineer specializing in PCB, RF, and high-speed digital design. I design reliable hardware using STM32, ESP32, RP2040, nRF52/nRF91, PIC, AVR, and NXP pla...
About this Gig
Need a reliable LoRa RF PCB for your IoT project? Im David, an Embedded Hardware Engineer specializing in custom PCB and wireless IoT design.
I can design PCBs integrating LoRa, RF circuits, LoRa antennas, PIC microcontrollers, MQTT, and AWS IoT based on your project requirements.
My services include:
- Circuit and schematic design
- LoRa RF PCB layout
- LoRa antenna integration
- PIC-based embedded hardware
- Component selection and footprints
- BOM preparation
- PCB 3D modeling
- Design simulation and analysis
- Fabrication-ready Gerber files
- Complete source files
Whether you need a prototype, sensor node, tracker, gateway, or connected IoT device, I focus on reliable, practical, and manufacturable designs.
Message me before ordering with your requirements so I can review your project and recommend the right package.
FAQ
Can you design a complete LoRa PCB from scratch?
Yes. I can handle the circuit design, schematic, component selection, PCB layout, LoRa/RF integration, antenna interface, BOM, and manufacturing files based on your requirements.
Can you design the LoRa RF section and antenna?
Yes. I can integrate the LoRa RF section and antenna into the PCB while considering RF layout, impedance, grounding, component placement, and antenna requirements
Can you work with an existing schematic or PCB?
Yes. I can review, modify, optimize, troubleshoot, or redesign an existing schematic or PCB layout to meet your project requirements.
Can you integrate PIC, MQTT and AWS IoT into the hardware design?
Yes. I can design the hardware around PIC microcontrollers and prepare the required interfaces and connectivity for MQTT and AWS IoT applications.
What do you need before starting the project?
Please provide your project requirements, preferred LoRa module or IC, MCU, board dimensions, power requirements, interfaces, antenna requirements, enclosure constraints, and any existing schematic or block diagram.
