I will design your dmx led fixture pcb and write the stm32 firmware
About this Gig
A standard control board costs a few dollars and works fine - until your fixture needs something that board does not do.
Battery power. A non-standard LED layout. Full RDM. Art-Net. OTA. That is where custom electronics starts.
WHAT YOU GET
- Schematic with component values
- PCB layout Gerber plus editable Altium source
- BOM with part numbers and sourcing notes
- Firmware source with build instructions
- Channel chart and test report
WHAT I BUILD
- DMX512-A in and out, isolated
- Multi-channel LED drivers, 16-bit dimming
- RDM responders, Art-Net, sACN
- Battery, wireless, OTA with rollback
- STM32, ESP32, nRF52. Buck, boost, linear drivers
WHO OWNS IT
You do, on final payment. Altium source, BOM, firmware and toolchain project included, no lock-in. Happy to sign an NDA.
TIMELINE
14 days for design files, 30 days with firmware. Two revisions included. PCB fabrication is not included - boards are ordered after design approval, typically 1-3 weeks.
Certification: I prepare the files and test plan; the test house runs the tests.
Send the mechanical envelope, LED configuration and what the fixture must do. Message me first - packages are starting points, not limits.
Specialization:
Circuit design
•
Schematics
•
Layout
•
Gerber
File format:
Gerber
•
STEP
•
SCH
•
•
ODB
Software:
Altium Designer
Interface:
I2S
•
UART
•
USB
•
SPI
•
Ethernet
Other Electronics Engineering Services I Offer
FAQ
Do you do the PCB layout as well as the schematic?
Yes. You get the Gerber files for manufacturing and the editable Altium files, so your factory or another engineer can take it over.
Can you work with the board we already have?
Yes, if you have the schematic and the source code. If you do not have the source, I will review what exists first and tell you honestly whether patching it is realistic.
Who owns the design and the source code?
You do. Schematic, layout, BOM, firmware source and documentation are all delivered to you, and the IP is yours on final payment.
Do you handle certification?
I prepare the design and the documentation for certification, but the test house runs the tests. I will tell you which standards apply to your market.
What happens if the first prototype does not work?
I review the prototype against the design and fix design or firmware faults free within 30 days. If the fault is in assembly or a substituted component, I will tell you exactly what to change.

