Browse categories
Explore
Fiverr Pro
English
$
USD
I will design drone pcb flight controller vtol pixhawk ardupilot uav electronics
pcb design
Hello! I'm theo harrison, a skilled Electronics Engineer with over 7 years of experience in PCB design and circuit development. I specialize in using advanced tools such as Altium, EasyEDA, Proteus, a...
About this Gig
Are you developing a custom drone, UAV, or multirotor platform?
I will design flight controller PCBs and embedded electronics tailored to your aircraft's hardware requirements.
My services include:
- Custom drone flight controller PCB design
- STM32 and other suitable MCU integration
- IMU, gyroscope, accelerometer, barometer, and magnetometer interfaces
- GNSS/GPS, telemetry, UART, CAN, SPI, and I2C connectivity
- ESC interfaces and PWM/DShot signal routing where supported
- Battery monitoring, voltage regulation, and power distribution
- Sensor placement, noise reduction, and compact PCB layout
- Schematic capture, BOM, Gerber files, and manufacturing documentation
- Existing UAV electronics review and hardware troubleshooting
Whether you are building a quadcopter, fixed-wing UAV, research drone, or custom aerial robotics prototype, I can help translate your specifications into a practical electronics design.
Please share your aircraft type, MCU preference, sensor list, battery voltage, ESC interface, PCB dimensions, and available reference files before ordering.
FAQ
Can you design a custom drone flight controller?
Yes. Share the aircraft type, controller requirements, sensors, interfaces, and preferred MCU so the design scope can be defined.
Can you integrate an IMU, barometer, and compass?
Yes. Component selection and placement depend on the required sensors, mechanical constraints, vibration environment, and noise considerations.
Can you add GPS and telemetry interfaces?
Yes. GNSS and telemetry hardware can be included based on the selected modules, protocols, antenna requirements, and available interfaces.
Can the controller support ArduPilot or PX4?
Hardware compatibility can be designed around suitable platform requirements, but firmware porting, board configuration, and validation must be scoped separately.
Can you integrate ESCs and battery monitoring?
Yes. The design depends on ESC signal protocols, battery voltage, current-sensing requirements, and whether power distribution is on the same PCB.
Will I receive manufacturing files?
The Standard and Premium packages include the agreed manufacturing outputs, such as Gerbers and BOM, plus specified design files.
Does the service include flight testing?
No, not by default. Flight testing, firmware validation, tuning, and airworthiness or regulatory assessments require separate scope and appropriate facilities.
