Browse categories
Explore
Fiverr Pro
English
$
USD
I will design your pcb layout and schematic in kicad, fab ready
Electrical Engineer
I'm a full time electronics engineer and I'm new to freelancing. My day job is PCB layout and firmware, mostly STM32 and FPGA boards. Most of what I do is power and motor drive. Buck converters, stepp...
About this Gig
I design STM32 and motor control boards. Stepper drivers, BLDC drivers, LED drivers, sensor boards, and the power supplies that feed them.
Send me a schematic and I'll lay out the board. Send me a circuit description or a photo of your breadboard and I'll draw the schematic first. Either way you get back a KiCad project you own outright, not just a folder of outputs.
What comes with every board:
- The full KiCad project, schematic and layout
- Gerbers, drill files, BOM and placement file, ready for JLCPCB or your fab
- DRC and ERC clean, nothing left unrouted
- A netlist check against the schematic, so what you fab is what you drew
- Every part checked for real stock and no end of life surprises
Power and motor boards are most of my work, so I watch what actually bites. Gate drive loops stay small. Power and signal ground get split properly. Current sense comes back as a real Kelvin connection. Copper gets sized for the current it carries, not guessed at.
To quote you properly I need the supply voltage, the current per channel, a rough part count, and any size limits. Not sure yet? Message me first and we'll work it out.
Specialization:
Circuit design
•
Schematics
•
Layout
•
Footprint
•
Gerber
File format:
Gerber
•
STEP
•
•
ODB
Software:
KiCad
•
LTspice
•
Arduino
My Portfolio
FAQ
What counts as a revision?
Adjustments to the delivered design: placement changes, silkscreen, minor routing preferences. Circuit changes (new parts, changed interfaces, new requirements) are scoped as a new order or the revision extra.
Do you write firmware?
Yes, for boards I design, as a custom offer. Message me with what the board needs to do and I'll quote it.
Do you do RF or antenna design?
? Module-based Wi-Fi/BLE (ESP32 and similar pre-certified modules) yes. Chip-level RF and custom antenna design, no.
What do I need to provide?
A schematic, netlist, or circuit description with part numbers, plus board size and mounting constraints. The order requirements form walks you through it.
Which fab can I use?
Any of them. Files follow standard gerber/drill conventions; BOM part codes target JLCPCB by default, tell me if you're using a different assembler.
