Browse categories
Explore
Fiverr Pro
English
$
USD
I will provide embedded systems development, microcontroller programm for arduino esp32
Embedded Systems Engineer IoT Developer ESP32 STM32 Arduino PCB Design
I am an Embedded Systems Engineer and IoT Developer specializing in firmware development, microcontroller programming, and PCB design using ESP32, STM32, and Arduino. I build reliable embedded systems...
About this Gig
Provide Embedded Systems Development, Microcontroller Programm for Arduino ESP32
Welcome,
Searching for professional Embedded Systems Development and Microcontroller Programming? You found it.
I provide expert level embedded development for Arduino, ESP32, and STM32 platforms precise, scalable, and engineered to your exact specifications. Built for serious projects.
WHAT I PROVIDE:
- Professional microcontroller programming
- Embedded systems architecture & development
- Arduino, ESP32 & STM32 custom firmware
- Driver development SPI, I²C, UART, CAN
- RTOS integration & real time task design
- Code review, optimization & documentation
DELIVERABLES:
- Production grade commented source code
- Architecture documentation
- Full debugging & unlimited revisions
Professional embedded development, delivered on time and built to last.
Share your specs I'll send you a clear project plan before we start!
Other Electronics Engineering Services I Offer
FAQ
What makes your embedded development 'professional grade'?
I follow industry best practices: modular code architecture, hardware abstraction layers (HAL), defensive programming, proper interrupt handling, MISRA-C guidelines where applicable, and thorough documentation the same standards used in
Can you develop firmware for industrial or commercial products?
Yes. I have experience building firmware for industrial sensors, commercial IoT gateways, medical monitoring devices, & automotive accessories. I follow production readiness standards including error handling, watchdog timer & safe state design
Do you support CAN Bus for automotive or industrial projects?
Yes. I implement CAN Bus communication on STM32 and ESP32 using standard or extended frames, with custom message handlers, error detection, and bus off recovery. Specify your baud rate and message protocol when ordering.
Can you write HAL and low level drivers from scratch?
Yes. I write custom Hardware Abstraction Layer (HAL) and Low-Level (LL) drivers for any peripheral Can you write HAL and low lev displays, motor controllers, ADC/DAC chips, wireless modules, and custom ICs based on the datasheet you provide.
Do you handle multi MCU communication in a single project?
Yes. I design and implement firmware for systems with multiple MCUs communicating over UART, SPI, I²C, or CAN Bus. I handle both master and slave firmware, message protocols, and synchronization logic.
Can you integrate FreeRTOS into an existing project?
Yes. I migrate bare-metal firmware to FreeRTOS converting main loops into tasks, implementing queues, semaphores, and mutexes for thread safety. I also tune task priorities and stack sizes to prevent overflow and starvation.
What development tools and IDEs do you use?
I work with STM32CubeIDE, Keil MDK, IAR Embedded Workbench, Arduino IDE, PlatformIO, VS Code, and ESP IDF. I use logic analyzers and oscilloscopes for hardware level debugging and can work in your preferred toolchain.
