I will design uhf rfid pcb, reader, antenna, firmware and embedded debugging system tag

United States

I speak English

Industrial Automation Specialist

Senior RF & High-Speed PCB Engineer and Industrial Automation Specialist. I deliver industrial-grade hardware, complex multi-layer PCB layouts, and robust firmware for ESP32, STM32, and UHF RFID syste...

About this Gig

Welcome!

I design custom UHF RFID readers, impedance-matched antennas, and low-level reader firmware. Zero guessworkevery RF frontend and PCB layout is engineered for 50-ohm signal integrity and maximum read range.

RF & Hardware Stacks:

ICs: Impinj R2000/E710, ST25RU3993
Antennas: Patch, ceramic, or PCB trace
Matching: Pi/Tee network & S11 tuning
Interfaces: UART, SPI, USB, GPIO

You Receive: Gerber files, BOM, antenna match network, and reader firmware.

Poor impedance matching kills read distance, EMI desensitizes receivers, and bad firmware drops tag packets. You need an RF board that reads tags reliably across the zone.

Stop spinning bad hardware. Send your read range goals and constraints now let's tune your RFID system today!