Browse categories
Explore
Fiverr Pro
English
$
USD
I will create rf and iot hardware test plan and pcb bring up procedures
RF Network Interface Engineer Wireless Ethernet CAN High Speed PCB Solution
I’m an RF and network-interface engineer helping hardware teams build reliable wireless and wired connectivity. I specialize in RF PCB layout, antenna matching, Wi-Fi, BLE, LoRa, NB-IoT, GNSS, Etherne...
About this Gig
Preparing to power up a new RF or IoT board? Our engineering team creates written test plans that help your technicians check hardware in a clear, repeatable sequence.
We cover agreed module-based Wi-Fi, BLE, LoRa, cellular and GNSS circuits, plus Ethernet, CAN and RS-485.
Deliverables include:
- Pre-power inspection checklist
- Power-rail verification steps
- Equipment and connection list
- Functional test procedures
- Measurement recording sheets
- Pass/fail criteria from your specifications
- Troubleshooting guidance.
Basic covers initial board power-up. Standard adds one communication circuit. Premium covers two circuits and a fault-isolation guide.
We tailor the documents to your schematic, component datasheets, available equipment and stated requirements. Missing specifications are flagged for agreement.
This gig provides documentation only. Physical testing, firmware, RF tuning, certification and guaranteed performance are excluded.
Message our team before ordering.
FAQ
Does your team physically test our board?
No. These packages provide written procedures for your team or test technician to execute. Physical measurements, equipment operation, and laboratory services are not included.
How is this different from your manufacturing documentation gig?
Our manufacturing gig prepares files for fabrication and assembly. This gig provides detailed procedures for checking assembled hardware, recording measurements, and investigating faults. Its scope goes beyond the brief bring-up checkl
What information do you need to create the plan?
We need your schematic, relevant component datasheets, power requirements, intended operating behavior, and available test equipment. PCB drawings, connector details, and firmware instructions may also be needed.
Can you prepare tests if we have limited equipment?
We can tailor the agreed procedures to your available tools. If a requested measurement needs equipment you do not have, we will identify that limitation rather than present an unsupported alternative as equivalent.
Will the plan prove that our product meets certification requirements?
No. This is an engineering test-documentation service, not certification or a compliance assessment. Pass/fail criteria must come from your agreed requirements or applicable component specifications; executing the plan does not g
