Browse categories
Explore
Fiverr Pro
English
$
USD
I will design uav dronecan can bus telemetry power distribution sensor interface board
UAV Robotics PCB Design STM32 Flight Controller and Embedded Systems
I design advanced UAV robotics and embedded electronics including STM32 flight controllers, PX4 autopilot boards, drone ESCs, CAN peripherals, power modules, and sensor fusion PCBs. My focus is reliab...
About this Gig
I design custom UAV CAN PCB hardware for DroneCAN telemetry, sensor nodes, power distribution, and embedded flight electronics.
Your board can integrate CAN transceivers, DroneCAN node electronics, GPS/GNSS, IMU, barometer, current sensing, voltage monitoring, UART, I2C, SPI, telemetry interfaces, regulated power rails, BEC outputs, filtering, protection, and rugged connectors.
I focus on practical hardware architecture: CAN bus topology, 120 ohm termination, TVS/ESD protection, reverse polarity protection, transient handling, power integrity, signal integrity, thermal considerations, grounding, decoupling, and clean connector placement. Designs can be prepared for PX4, ArduPilot, Pixhawk, and DroneCAN based systems.
Deliverables can include schematic, multilayer PCB layout, BOM, component selection, PCB 3D, Gerber/ODB++ production files, fabrication notes, and design documentation. Need a CAN power module, UAV telemetry node, sensor interface, PDB, BEC board, or custom robotics CAN peripheral? Send your voltage/current targets, interfaces, enclosure constraints, and required sensors.
FAQ
Can you design a custom DroneCAN PCB for PX4 or ArduPilot?
Yes. I can design custom DroneCAN hardware for PX4, ArduPilot and Pixhawk-based UAV systems, including CAN nodes, power modules, sensor interfaces and telemetry peripherals.
What sensors and interfaces can you integrate?
I can integrate GPS/GNSS, IMU, barometer, magnetometer, current and voltage sensing, I2C, SPI, UART and other required sensor or communication interfaces.
Can you design a UAV CAN power distribution PCB?
Yes. The board can combine CAN communication with power distribution, regulated rails, BEC outputs, current monitoring, voltage measurement, filtering and protection according to your system requirements.
Do you include CAN bus protection and termination?
Yes. The hardware can include 120 ohm CAN termination, TVS/ESD protection, transient protection, appropriate filtering, grounding, decoupling and connector considerations.
Can you make a DroneCAN telemetry or sensor node?
Yes. I can create dedicated DroneCAN nodes for GPS, sensors, power monitoring, telemetry and other UAV or robotics peripherals. Generic CAN nodes can also bridge I2C, SPI or UART devices to the CAN network.
What PCB design files will I receive?
Depending on the package, deliverables can include schematic, PCB layout, BOM, component selection, 3D board, Gerber or ODB++ files, fabrication notes and design documentation.
Can you design the PCB for a specific voltage and current?
Yes. Provide your battery range, continuous and peak current, output rails, connectors and load requirements. I can size the power path, protection, regulation, sensing and thermal considerations around those specifications.
Can you design the complete UAV CAN hardware architecture?
Yes. For larger projects, I can develop the architecture around CAN nodes, power distribution, telemetry, sensors, GPS/GNSS, BEC regulation, current sensing and flight-controller interfaces.
