Browse categories
Explore
Fiverr Pro
English
$
USD
I will embedded linux, raspberry pi cm4 cm5 radxa can bus motion controller pcb design
Embedded Automation Engineer CM5, PLC CODESYS, SCADA, HMI LVGL iot Developer
I am an Embedded Systems & Industrial Automation Engineer specializing in CM (Compute Module 1, 2,3, 4, 5), embedded Linux, CODESYS PLC programming, Ladder Logic, Structured Text (ST), SCADA systems, ...
About this Gig
Embedded Linux PCB Design CM4/CM5 & Radxa CAN Bus Motion Controller
I am an Embedded Systems & Hardware Design Engineer specializing in Embedded Linux systems, CAN bus motion control, and industrial PCB design for robotics and automation applications.
I design production-ready embedded control systems using Raspberry Pi CM4/CM5, Radxa CM5, and other Linux-based compute platforms, focusing on high-performance motion control, real-time communication, and scalable IoT/robotics architectures.
MY SERVICE ARE:
- Embedded Linux system
- Raspberry Pi CM4/CM5 development
- Radxa CM5 integration
- CAN bus
- CAN-FD motion controller
- Industrial motion control systems
- Robotics control
- IoT embedded systems
- PCB schematic
- PCB layout design
- Multi-layer PCB
- Motor control system
- Actuator control systems
- Sensor integration (IMU, Lidar, encoder, ultrasonic)
- Power management design
- Signal integrity optimization
- Embedded Linux networking
- Hardware architecture
- Manufacturing-ready PCB files
- Gerber file generation
- BOM creation
- STEP file export
- Industrial automation systems
Contact me before placing an order to discuss your embedded system project
FAQ
What information do you need to start my project?
I need your system requirements, block diagram (if available), power specs, number of motors/actuators, sensor list, communication needs (CAN, Ethernet, etc.), and target platform (CM4/CM5/Radxa).
Can you design a complete embedded Linux system?
Yes, I design full embedded Linux hardware systems including CM4/CM5/Radxa carrier boards, CAN bus integration, and industrial control architecture.
Do you provide PCB manufacturing files?
Yes, you will receive Gerber files, BOM (Bill of Materials), and STEP files ready for manufacturing.
Can you design CAN bus or CAN-FD systems?
Yes, I specialize in CAN bus and CAN-FD based motion control systems for robotics and industrial automation.
Do you support robotics and motion control projects?
Yes, I design motion control architectures for robotics, actuators, and industrial automation systems.
Can you integrate sensors into the system?
Yes, I can integrate sensors such as IMU, Lidar, encoder, ultrasonic, pressure, and more depending on your project.
