I will develop pcb design cm5 compute module raspberry pi altium designer dfm review
PCB Design Engineer, IoT and Embedded Boards
About this Gig
Do you need pcb design for a Raspberry Pi CM5 or CM4 carrier board that boots and runs stable?
I design compute module carrier boards for embedded products. You send the ports you need. You get a layout checked for each interface, ready to order.
What I do:
- Carrier schematic design for CM5 and CM4 modules
- Footprints for the two 100-pin board-to-board connectors
- USB 3.0, HDMI, PCIe, Gigabit Ethernet and MIPI DSI/CSI routing
- 4-layer and 6-layer stackup with impedance notes
- Length-matched differential pairs and ground return vias
- Power input, protection and 5 V rail sizing for peak load
- Design rule check, electrical rule check and DFM review
Tools: Altium Designer, KiCad
You receive: native project files, schematic PDF, Gerber and drill files, stackup note, BOM, pick-and-place file, 3D STEP model.
Why it works:
- I match pair lengths and keep each pair over solid ground, the usual cause of dropped USB and PCIe links
- Parts are checked for stock and footprint before layout
- Revisions cover changes inside the agreed design; a new concept or board size is quoted as a custom offer.
Message me your port list and board size, and I will send a clear plan.
Other Electronics Engineering Services I Offer
FAQ
What do you need from me to start?
The module you use (CM5 or CM4), the ports and interfaces you need, board size, power source and any enclosure details. A block diagram or sketch helps. I can suggest a port plan if you only have the product idea.
Can you work from a sketch or photo?
Yes. Send a sketch, a photo of an existing board or a schematic you have the right to use. I draw the carrier schematic, list the parts and confirm open points with you before layout starts.
Will my board house accept your files?
Yes. I note the stackup, copper weight and impedance targets in a fab note and export standard Gerber and drill files. Board houses with impedance control, such as JLCPCB and PCBWay, can build it. Tell me which one you plan to use.
How do you protect USB 3.0 and PCIe signal quality?
I route each pair over solid ground, match lengths, avoid plane splits and add ground vias at layer changes. I note impedance targets in the stackup. Final speed also depends on your board house and parts.
Which carrier features can you add?
M.2 NVMe slot, dual HDMI, camera and display connectors, Gigabit Ethernet, RTC battery, fan header, 12 V input and a GPIO header. Tell me the ports you need and I confirm what fits your board size.
Can one board work with both CM4 and CM5?
CM4 and CM5 share the connector style and size, but some pins and power needs differ. Tell me if you want one board for both and I check each pin before layout, then list any limits.
Do you build, print or ship boards?
No. I deliver design files only. You send them to a board house or assembly service of your choice. I can explain the ordering steps. I do not make, assemble, test or ship physical boards.
How do revisions work?
Included revisions: 2 on Basic, 3 on Standard, 5 on Premium. They cover changes inside the agreed design. A new concept or a changed board size or brief is quoted as a custom offer, so your first price stays fair.
What changes the price?
Layer count, number of interfaces, high-speed ports, board size limits, power needs and how finished your schematic is. Send your port list and I quote before you order.
Do I own the files and can I sell what I make?
Yes. On completion you own the delivered design files and can build and sell products from them. You must own any logo or artwork you supply. I do not reuse your design for other clients.

