I will do arduino programming, esp32 coding, iot, rp2040 embedded systems, esp8266,
PCB Design Engineer, IoT and Embedded Boards
About this Gig
Do you need pcb design for an STM32 or RP2040 board that boots and flashes first time?
I design microcontroller boards for embedded products, dev boards and Arduino shields. You send the chip and a short feature list. You get a clean board ready to order, with a matching pin map.
What I do:
- STM32 and RP2040 schematic design with clock and reset circuits
- Decoupling at every power pin, placed beside the chip
- USB-C, SWD or UART programming header and boot buttons
- Motor driver, relay driver and analog sensor sections
- 2-layer and 4-layer pcb layout with solid ground return
- Design rule check, electrical rule check and Gerber export
Tools: KiCad, EasyEDA, Altium Designer
You receive: native project files, schematic PDF, Gerber and drill files, BOM, pick-and-place file, pin map sheet.
Why it works:
- I place decoupling caps and the crystal close to the chip, since long traces there cause unstable boots
- Every part is checked for stock and footprint before layout
- Revisions cover changes inside the agreed design; a new concept or board size is quoted as a custom offer.
Message me the chip name, your port list and board size, and I will send a clear plan.
Other Electronics Engineering Services I Offer
FAQ
What do you need from me to start?
The chip or family (STM32 or RP2040), the ports and pins you need, board size, power source and any shield or module outline to match. A sketch or parts list helps. I can propose a chip if you only have the feature list.
Can you work from a sketch or photo?
Yes. Send a hand sketch, a breadboard photo or an existing schematic with pin labels. I draw a clean schematic, list the parts and confirm open points with you before layout starts.
Will my board house accept your files?
Yes. I export standard Gerber and drill files with a layer map and match the capability sheet of your board house. JLCPCB, PCBWay and others publish theirs. Tell me which one you plan to use.
How do you make the board boot and flash reliably?
I add the boot pin or button circuit, an SWD or USB programming header, a clean reset line and decoupling at each power pin, placed close to the chip. The crystal sits beside the chip with short traces and a ground guard.
Can you design an Arduino shield or Nano style board?
Yes. I match the shield or Nano outline, header spacing and pin order. Send the host board name and the parts you want on the shield. I check header positions against the host board before I finish the layout.
Can you add motor drivers, relays or analog inputs?
Yes, for low-voltage stages up to the limits you state. Mains-voltage or safety-rated designs need review by your adviser, who confirms final compliance. I lay out the circuit you specify and do not certify it.
Do you build, print or ship boards?
No. I deliver design files only. You send them to a board house or assembly service of your choice. I can explain the ordering steps. I do not make, assemble, test or ship physical boards.
How do revisions work?
Included revisions: 2 on Basic, 3 on Standard, 5 on Premium. They cover changes inside the agreed design. A new concept or a changed board size or brief is quoted as a custom offer, so your first price stays fair.
What changes the price?
Layer count, part count, analog or motor sections, board outline limits and how finished your schematic is. A tight shield outline takes more time. Send your details and I quote before you order.
Do I own the files and can I sell what I make?
Yes. On completion you own the delivered design files and can build and sell products from them. You must own any logo or artwork you supply. I do not reuse your design for other clients.

