Browse categories
Explore
Fiverr Pro
English
$
USD
I will review and debug your schematic and pcb design
DFM and DFMA Engineer, Turning Designs into Production Ready Products
I’m Fernando Perez, a DFM/DFMA engineer with over 12 years of experience in mechanical, electronic, and mixed-assembly product development. I specialize in identifying manufacturing risks early and op...
About this Gig
Your board doesn't boot. Or it overheats. Or it passed simulation and failed in the real world. This is the gig for that.
THE FIX-IT PROCESS
- Send schematics + Gerbers + the failure symptom
- I run a full DRC/ERC pass + signal integrity review (power planes, decoupling, trace impedance, thermal)
- You get a marked-up report: root cause, not guesses
- I redesign the faulty section or the whole board if needed
- Re-verified files, ready for re-fab
COMPONENT SELECTION
I cross-reference datasheets against real distributor stock (Digikey/Mouser/LCSC) so your BOM doesn't die in 6 months
from an EOL part, a mistake that kills more production runs than bad routing does.
BEST FIT FOR
Founders whose contract manufacturer rejected a board, hardware teams debugging field failures, anyone who got a
"finished" design that doesn't actually work.
Attach your schematic/Gerbers and describe the symptom, I'll give you a real diagnosis before any payment
