I will debug and fix your arduino, esp32 or embedded c code

Your code compiles but the device doesn't behave. Or it works for ten minutes

and then stops. I find out why.

I'm an electronics engineer, so I debug the hardware and the software together

which matters, because "the code is broken" is very often a floating pin, a

brownout, a missing pull-up or a power supply that can't hold up under load.

SEND ME

Your code, your wiring or schematic, and a description of what actually

happens versus what should happen. Error messages and serial output help.

YOU GET BACK

Fixed, commented code. A written explanation of what was wrong and why so

the same bug doesn't cost you a week next time.

I'll tell you honestly if the problem is beyond what I can fix remotely

without the board in front of me, and I'll say that before you order rather

than after.