I will iot rf pcb design for esp32, lora, gps, and satellite communication systems

Connected devices live or die by their radio link. An ESP32 board with a poorly matched antenna, a LoRa module with the wrong ground plane, or a GPS receiver starved by RF noise may never lock a signal at all. IoT hardware demands the same RF discipline as any wireless system, just packed into a smaller board.

I design RF PCBs for IoT applications ESP32-based boards, LoRa/LoRaWAN nodes, GPS/GNSS modules, and satellite communication hardware. Every layout is built around proper antenna integration, impedance-matched RF traces, and clean grounding, so your device connects reliably from the first prototype through production.

What you get:

• Schematic design around your chosen module
• RF-aware PCB layout with antenna placement and matching
• Power and grounding design for low-noise RF performance
• Manufacturing-ready Gerber files and BOM
• Design review focused on real-world connectivity

I work with Altium Designer, KiCad, and Eagle, across ESP32, LoRa/LoRaWAN, GPS/GNSS, and satellite (Iridium, NB-IoT) integrations.

Whether you're building a single prototype or scaling an IoT product, I design boards that connect the first time not the fifth.

Message me your specs before ordering.