I will create technical drawing or draft using solidworks

Welding Table1: (1st Image)

In this drawing document, detail of all the structural members / items of this welding table is given, as the cut list.

Knuckle Joint (eDrawings Drawing): (2nd Image)

• I opened the drawing document of knuckle joint (which I had created in SolidWorks Drawings) in eDrawings.
• Saved the document as eDrawings Drawing file.
• There are 4 views, upper left 'front view', upper right 'left view', lower left 'top view', and lower right 'section view'.
• I started the animation. In manual play, by pressing the 'next' button, it played for the front view as the next view, after the front view was played, it stopped, now by pressing the 'previous' button, it played for the section view as the previous view (conversion of the front view back to the section view), after the previous view was played, it stopped. Then I started the continuous play, by pressing the 'play' button, it

played for all 4 views (one by one) continuously. After observing this animation for

certain time, I stopped the continuous play by pressing the 'stop' button, and then

reset the positions and orientations of all views.