Browse categories
English
$
USD
Connect to your AI
I will design custom pcb for esp32, raspberry pi cm4, cm5, arduino and iot projects
About this Gig
Dead prototype? Missed deadline? Designer ghosted with your files? Breathe. You're safe here. I fix it and build it right, fab-ready. Custom PCB design for ESP32, Raspberry Pi CM4/CM5, Arduino & IoT projects.
WHAT YOU GET:
Circuit design
Schematics
PCB layout, 2-6 layers
Gerber + drill files
BOM + pick-and-place
CM4/CM5 carrier boards
ESP32 custom boards
Arduino custom boards
USB, UART, SPI, I2C, CAN
Wi-Fi, BLE, Ethernet
PCIe, HDMI, MIPI DSI/CSI
High-speed routing
Impedance control
Custom footprints
DRC/ERC checks
STEP 3D model
Antenna & power layout
Failed-board rescue/redesign
JLCPCB/PCBWay ready
KiCad, Altium, EasyEDA
Full source files, you own them
Fab questions handled
Schematic PDF
Fast revisions
Post-delivery support
Raspberry Pi CM4/CM5 IO boards
CM4/CM5 NVMe/PCIe boards
ESP32-S3, C3 and P4 custom boards
ESP32 sensor and data-logger boards
Arduino shield design
Smart home and relay boards
Industrial IoT gateway boards
Battery-powered, low-power boards
LoRa and mesh node boards
Wearable and compact boards
Don't gamble your next prototype. Message me BEFORE ordering: send your idea and get a free feasibility check. I'm the designer you'll stop looking for.
FAQ
Can you design a custom PCB for ESP32, Arduino or Raspberry Pi CM4/CM5?
Yes. I design custom PCB layouts, schematics and Gerber files for ESP32, Arduino, Raspberry Pi CM4/CM5 carrier boards and IoT projects. Send your idea, sketch or part list and I’ll confirm what’s possible before you order.
What files will I receive, and do I own the PCB design?
You get Gerber and drill files, BOM, pick-and-place, schematic PDF, STEP 3D model and full source files (KiCad, Altium or EasyEDA). Everything is yours after delivery, ready for JLCPCB or PCBWay manufacturing and assembly.
Do you handle high-speed CM4/CM5 routing like PCIe, HDMI, USB, Ethernet and MIPI?
Yes. I do high-speed PCB routing with impedance control, differential pairs and length matching for PCIe, HDMI, USB, Ethernet and MIPI DSI/CSI, then run DRC/ERC checks before delivery. Complex boards fit the Premium package
My PCB prototype doesn’t work. Can you review or redesign it?
Yes. Send your schematic, layout and Gerber files for a design review. I check power, footprints, routing and DFM, then fix or redesign your IoT PCB so it’s prototype-ready. Message me first for a free feasibility check.
